Skip to content
Recovery4.1

The Pod Company Cold Plunge Chiller Review: 5°C for Under £500

Mike Shilling

By Mike Shilling, Recovery & Training Editor · Updated 17 November 2026

We may earn a commission from qualifying purchases made through links on this page, at no extra cost to you. This never affects our ratings.

The Pod Company Cold Plunge Chiller Review: 5°C for Under £500
The Pod Company 1/3 HP Cold Plunge Water Chiller, Cools to 5°C

The Pod Company

The Pod Company 1/3 HP Cold Plunge Water Chiller, Cools to 5°C

4.1

The Pod Company's Standard chiller is a small, 1/3 HP cooling unit that pumps water out of your cold plunge, chills it and sends it back, holding it down to a stated 5°C. It's sold on Amazon UK for around £498.95 at the time of writing, and was in stock when we checked on 17 November 2026. That's a lot less than most chillers, and roughly £190 below the AS ColdPlunge chiller we reviewed last month.

What surprised us is how much The Pod Company actually tells you. Wattage, minimum temperature, noise, a rough pull-down time: these are the numbers most budget chiller listings leave out, and they're all published here. The trade-offs are a slow first chill, monthly paper filters and no stated tub capacity.

How we review

We haven't tested this chiller ourselves. This review is built from the Amazon UK listing, The Pod Company's own UK product page and support FAQ, patterns in owner feedback, and our own running-cost sums, which we show in full. Where the maker's figures are vague or the listing contradicts itself, we say so.

Check the Pod Chiller price on Amazonaround £499

What you're buying

The Pod Company sells the Standard chiller as a partner to its own Ice Pod Pro and Long Pod tubs, but it isn't locked to them. Amazon's listing says it works with "most tubs featuring inlet/outlet valves", and the brand's chiller FAQ says it connects to any ice bath using one valve. Hoses and fittings come in the box.

On paper it's a simple machine. A pump draws water through a filter and across a cooling coil, a thermostat lets you set the target, and the compressor cycles on and off to hold it. The unit measures 30 x 30 x 33cm according to The Pod Company's UK product page, so it'll sit beside a tub without taking over a patio. It runs on a standard UK plug at 220 to 240V, and the FAQ recommends an RCD-protected socket for outdoor use. We'd go further and say always use one: it's a mains appliance next to a few hundred litres of water.

One thing to be aware of: the "Included components" field on the Amazon listing describes a tub, a Pro chiller and a lid, which doesn't match the product title or the bullet points. The title, bullets and price all point to the standalone Standard chiller, and The Pod Company's own store sells that unit alone for £499. If you're unsure, check what's in the order before you confirm.

The Pod Company Standard chiller key specs
Compressor1/3 HP
Minimum temperature5°C
Power draw280W, only while cooling
Noise (maker's figure)About 39 dB
Filter20-micron paper filter; clean weekly, replace monthly
SanitisingNo UV or ozone mentioned
ConnectionSingle-valve tubs; inlet/outlet tubs; hoses and fittings included
Dimensions30 x 30 x 33 cm
Power supplyUK plug, 220 to 240V
Rated tub capacityNot stated
Model numberC-CR02
Price checked£498.95 on Amazon UK, in stock (17 November 2026)

How fast does a 1/3 HP chiller really cool?

Slower than most people expect. A chiller this size isn't an ice dump; it removes heat gradually, and how long that takes depends on how much water you've got, how warm it starts and how warm the air around the tub is.

The Pod Company gives one useful anchor. Its FAQ says the bigger Pro chiller (0.5 HP, 500W) typically takes about 3 to 6 hours on first use to bring water from 21 to 32°C down to 4 to 7°C, and that the Pro cools roughly twice as fast as the Standard. That suggests the Standard needs something like 6 to 12 hours for the same job. That range is our extrapolation, not a Pod figure, and a bigger tub or a hot garage will push it longer.

In practice that's fine, as long as you plan for it. Fill the tub in the evening, switch the chiller on, and it should be at temperature by the next day. After that it only has to win back what the water gains through the tub walls and from your body, which is a much smaller job. The Amazon bullet promising cold water "in just a few hours depending on conditions" is fair for topping up a tub that's already cool, and optimistic for a first fill on a warm day.

The one gap here is capacity. Neither the Amazon listing nor the FAQ gives a maximum tub volume. For comparison, the AS ColdPlunge is rated for about 300 litres on the same 1/3 HP compressor size, and we'd treat that as a sensible ceiling for this unit too.

Running costs

The Pod Company says the Standard draws 280W, and only while it's actively cooling. That makes the maths easy. At 25p per kWh, a round figure close to recent UK capped rates, each hour of compressor time costs 7p.

Compressor time per dayEnergy per dayApprox cost per month
4 hours1.1 kWh£8
6 hours1.7 kWh£13
12 hours3.4 kWh£25
24 hours (worst case)6.7 kWh£50

How many hours it runs comes down to where the tub lives. A covered tub in a cool garage in spring will sit near the top rows. An uncovered tub on a sunny patio in July could run for most of the day. A lid, shade and keeping the hoses short make a bigger difference than the chiller itself. Even the worst case is a fraction of buying 25kg or more of ice for each session, which is what our AS ColdPlunge review worked out a 300 litre tub needs in summer.

Add the filters to that. A two-pack of replacement filters costs £26 on The Pod Company's UK store, and it advises changing them monthly, so that's about £13 a month if you follow the advice to the letter. The AS ColdPlunge uses a rinsable metal filter with no cartridges, so over a few years that gap eats into the Pod's price advantage.

Filtration and keeping the water clean

The filter is a 20-micron paper element. That's fine enough to trap hair, skin flakes and grit. The Pod Company advises cleaning it weekly.

What the filter doesn't do is disinfect. There's no UV lamp or ozone generator mentioned anywhere, so bacteria aren't being killed as water passes through. You'll still need a sanitiser in the tub, a lid on between sessions and regular water changes. Our guide on how to clean an ice bath covers dosing, how often to change the water with a filter running, and how to flush a chiller's pipework, which is where biofilm likes to build up.

Noise

The Pod Company quotes about 39 dB for the Standard and about 50 dB for the Pro, comparing the Pro to a typical fridge. The 39 dB figure is low for a compressor, and the FAQ doesn't say at what distance it was measured. We'd read it as "quiet enough for a garage or a garden" rather than as a lab result. If the unit will sit under a bedroom window, it's worth bearing in mind that a compressor cycling on at 3am is more noticeable than the same sound in the afternoon.

Will it work with an inflatable tub?

Usually, yes, if the tub has ports. The chiller is built around a simple valve connection rather than fixed plumbing. Most chiller-ready inflatables have an inlet and outlet, and the listing says the chiller suits tubs with those.

The Crydip XXL is a good example of where the fit gets tight. It has chiller ports, but we estimated its realistic fill at 350 to 450 litres, well past what we'd expect a 1/3 HP unit to handle briskly. It would still cool it; it would just take longer, especially in summer. A shallower fill helps.

Tubs with no ports at all are harder. You can run hoses over the rim, but you'll need to keep the intake under water and the joins secure, and that's a fiddlier set-up than the plug-and-play pitch suggests. If you're buying a tub with a chiller in mind, pick one with valves.

Pod Chiller vs AS ColdPlunge

Both are 1/3 HP units aimed at home plungers, and both are sensible buys for the right tub. Where they differ is on price and paperwork.

Pod Company StandardAS ColdPlunge
Price checkedAround £499Around £687
Power draw280W (stated)Not stated
Minimum temperature5°C (stated)Not clearly stated
Rated tub sizeNot statedUp to about 300 litres
FilterPaper, replaced monthlyRinsable metal, no cartridges
NoiseAbout 39 dB (maker's figure)Not stated
Size30 x 30 x 33 cmAbout 30 x 38 x 32 cm
AvailabilityIn stock6 to 7 day dispatch when we checked

The Pod wins on price and on published specs; we flagged the AS listing's impossible "12°F" claim and missing wattage in that review, and none of those gaps exist here. The AS wins on filter running costs and gives you a tub size to plan around. If you want the most clarity for the least money, we'd lean to the Pod.

Pros

  • Around £499, well below most 1/3 HP chillers
  • Published 280W power draw, so running costs are easy to work out
  • Clear 5°C minimum temperature
  • Maker quotes about 39 dB, quiet for a compressor
  • Compact 30 x 30 x 33 cm footprint and UK plug
  • Hoses and fittings included; works with single-valve and port-equipped tubs

Cons

  • First chill from warm water can take most of a day
  • No rated tub capacity published
  • Paper filters to replace monthly, about £13 a month
  • No UV or ozone, so you still need a sanitiser
  • Amazon listing's components field doesn't match the product
  • Base warranty length not clearly stated; a 2-year cover costs £89 extra direct

What the research says about cold water

A chiller makes daily plunging easy, so it's worth knowing what that cold actually does. A 2016 meta-analysis of nine trials found cold-water immersion eased muscle soreness slightly more than passive rest, with the best results at roughly 11 to 15°C for 11 to 15 minutes. That's relevant here: you don't need to run the Pod at its 5°C floor to get the soreness benefit, and holding 12°C costs less in electricity. Our guide on whether to plunge before or after a workout covers timing in more detail.

There's a real downside for anyone training for muscle size. A 2024 meta-analysis of eight studies concluded that cold-water immersion straight after resistance training may blunt muscle growth compared with training alone. The authors rated the studies fair to poor in quality, so it's not settled, but it's enough for us to suggest keeping plunges away from lifting sessions if hypertrophy is the goal. A chiller that's always cold makes a post-gym plunge tempting. That's the habit to think twice about.

See The Pod Company chiller on Amazonaround £499

Who should buy it

Buy it if you plunge most days from spring to autumn, you've got (or are buying) a tub with a valve or ports, and you don't want to pay £700 or more for a chiller. It's a particularly easy pick if you already own an Ice Pod.

Skip it if you plunge only in winter, when UK tap water arrives cold enough on its own. Skip it too if your tub holds well over 300 litres and you want fast pull-downs in summer; a 0.5 HP unit such as The Pod Company's own Pro is the better match there. And if you hate consumables, the AS ColdPlunge's rinsable filter may suit you better despite the higher price.

Recommended reads

Frequently asked questions

Is The Pod Company chiller worth it?

If you plunge four or more times a week outside the coldest months, yes. At around £499 it's roughly £190 cheaper than the AS ColdPlunge chiller we reviewed, and The Pod Company publishes the numbers that matter: 280W power draw, a 5°C minimum and about 39 dB of noise. If you only plunge in winter, cold tap water does most of the work for free.

How long does the Pod Chiller take to cool the water?

The Pod Company's own FAQ says its bigger Pro chiller takes about 3 to 6 hours on first use to bring water from 21 to 32°C down to 4 to 7°C, and that the Pro cools roughly twice as fast as this Standard model. By that logic, plan on several hours to most of a day for a first fill of warm water. Once it's down, holding temperature is far quicker.

How much does it cost to run?

It draws 280W only while the compressor is running. At 25p per kWh, that's 7p per hour of cooling. Six hours a day comes to about £13 a month, 12 hours a day about £25. Keep the tub covered and out of direct sun and the real figure should sit at the lower end.

Will it work with an inflatable ice bath?

It works with tubs that have an inlet and outlet valve, according to the Amazon listing, and The Pod Company says it connects to any ice bath using one valve. Most chiller-ready inflatables, such as the Crydip XXL, have ports. A cheap inflatable without ports will need a workaround, and very large tubs will cool slowly on a 1/3 HP unit.

Does the Pod Chiller keep the water clean?

It circulates water through a 20-micron paper filter, which catches hair and debris. The Pod Company advises cleaning it weekly and its replacement filter page says to change it monthly. There's no UV or ozone mentioned, so you still need to cover the tub, shower first, use a sanitiser and change the water regularly.

Is the Pod Chiller noisy?

The Pod Company quotes about 39 dB for the Standard chiller and about 50 dB for the Pro, which it compares to a typical fridge. It doesn't say how far from the unit that was measured, so treat it as a guide. A compressor this size near a bedroom window may still be noticeable at night.

Related guides

Best Exercise is a participant in the Amazon EU Associates Programme, an affiliate advertising programme designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.co.uk. As an Amazon Associate we earn from qualifying purchases. This comes at no extra cost to you and never influences our independent reviews or rankings.