YTW Raises: How to Do the YTW Exercise, Muscles Worked and Cues
How to do YTW raises face down on an incline bench, bent over or on the floor. Muscles worked, form cues, how light to go, sets and reps, mistakes and variations.
By Nadia Popescu, Strength & Conditioning Writer · Updated 17 November 2026
A single leg calf raise is a calf raise done on one foot, ideally with your heel hanging off a step. It sounds like a minor tweak to the standard version. It isn't. Moving from two feet to one doubles the load on each calf without any equipment, gives you a far deeper stretch than flat-floor raises, and exposes the weak side that two-footed work happily covers up. Physios use it as a strength test, runners use it to keep their Achilles healthy, and anyone training at home without a leg press can use it to make calf training properly hard.
Our general calf raises guide covers the basics of the movement and the muscles involved. This page goes deep on the one-legged version: how to set up the step, how slow to go, how to add weight, the bent-knee version, and how many reps you should be able to manage.
You need a step, a sturdy box or the bottom stair at home, plus something to hold. A wall, a banister or the upright of a squat rack all work.
Use a step whenever you can
Doing single leg calf raises on flat ground cuts off the bottom of the movement, which is where your calf is most stretched. A step of 10cm or more lets your heel drop well below your toes. That extra range makes the same bodyweight noticeably harder and is one of the cheapest upgrades in calf training.
A good default is 2-1-1-1: two seconds down, one second paused in the stretch, one second up, one second squeezed at the top. That makes a set of 15 last about 75 seconds, which is about right for the calves. Rushing through the same 15 reps in 20 seconds lets bounce from the tendon carry most of the load.
Every rep should go from a full stretch at the bottom to your highest possible heel position at the top. Most people lose range from the top first as they tire, so the last few reps quietly shrink into half-reps. Once you can't reach close to the height you managed on rep one, the set is over.
The single leg calf raise trains the triceps surae: the two heads of the gastrocnemius plus the soleus, which together insert into the Achilles tendon. With the knee straight, both work hard, and the gastrocnemius gets plenty of stretch at the bottom of a deficit rep.
Because you're on one foot, the smaller muscles around the ankle and foot also have to keep you from rolling in or out. That's tibialis posterior, the peroneals and the toe flexors. It's a big reason single-leg raises feel so different from a machine calf raise at the same load. For the opposite side of the lower leg, pair them with tibialis raises.
This is where the single-leg version becomes useful as a test as well as an exercise. The heel-rise test (single-leg raises to fatigue) is one of the most common calf strength checks in physio clinics, and there's decent normative data for it.
A 2025 study of 500 adults with no history of Achilles problems measured single-leg raises to fatigue with a phone app. Median scores were 25 reps on the dominant leg and 24 on the non-dominant leg, with a median peak heel height of a little over 9cm. There was no meaningful difference between dominant and non-dominant legs, and lower activity levels, female sex and higher BMI all went with lower scores (normative calf strength-endurance values).
An earlier study of 566 adults aged 20 to 81, doing the test on a 10 degree incline, found a median of 24 reps for men and 21 for women, with excellent test-retest reliability. Older women (over 60) actually outperformed older men (updated heel-rise test norms).
Two practical takeaways:
Once you can do 20 or more slow, full-range reps on each leg, bodyweight stops building much strength. Add weight.
Hold a dumbbell in the same-side hand as the working leg, with your other hand on the wall. The dumbbell hangs straight down beside the working foot, so your balance hardly changes. Start light, around 5kg to 10kg, because the extra range from the step makes even small weights feel heavy. A set of adjustable dumbbells lets you go up in small jumps, which suits calves better than big leaps.
A weighted vest or a loaded backpack works too, and frees up both hands for balance. For heavier loading than you can hold in one hand, switch to a machine version such as the leg press calf raise.
Bend your working knee by about 20 to 30 degrees and keep it bent throughout. Your heel still drops off the step and rises as high as it can, but the gastrocnemius, which crosses the knee, goes partly slack. That leaves more of the work to the soleus.
This version matters most for runners. The soleus takes a large share of the load each time your foot lands and pushes off, and it's often the weak link when calves cramp or tire late in a long run. It also feels a lot harder than people expect; most manage noticeably fewer bent-knee reps than straight-knee ones.
Don't swap your straight-knee work for it, though. Research comparing standing and seated calf training found standing produced more growth across the whole calf, the soleus included, which our seated calf raise guide goes into. Treat the bent-knee raise as the second exercise, after your straight-knee sets.
The Achilles tendon takes a heavy hit on every running stride. Tendons get stronger when you load them progressively, and the single leg calf raise is one of the simplest ways to do that at home.
The best-known evidence comes from Achilles rehab. In a 1998 study, 15 recreational athletes in their early forties with long-standing Achilles tendinosis did 12 weeks of heavy eccentric calf training (lowering slowly under load). All 15 were back to full running by the end, and calf strength on the injured side had caught up with the healthy side; a comparison group treated with rest and conventional care all ended up having surgery (heavy-load eccentric calf training). It was a small study without randomisation, so don't read it as proof that calf raises cure tendon pain. Still, the principle it helped establish, that tendons need load rather than rest, now underpins most Achilles rehab.
If you already have Achilles pain, get it assessed by a physio before building your own programme. Mild discomfort during loading is often acceptable in rehab, but sharp pain, swelling or a sudden "kick in the back of the leg" feeling is not something to train through. Pair the strength work with ankle mobility exercises and sensible calf stretches if stiffness is limiting your range, and tidy up your stride with our treadmill running form guide.
Move to the next stage once you can manage the target reps on both legs with a full range and the 2-1-1-1 tempo.
Bouncing at the bottom. The Achilles is springy, which is great for running and unhelpful here. A one-second pause in the stretch fixes it.
Shrinking reps. The top of the movement quietly disappears as fatigue builds. Count only the reps that reach close to your best height.
Pulling on the support. If your knuckles go white on the banister, your arm is doing part of the lift. Fingertips only.
Rolling to the outside of the foot. Under fatigue, many people drift onto the little toe side. Keep pressure through the big toe, and stop the set if the ankle starts wobbling out.
Letting the strong leg set the pace. Start with the weaker leg and stop the stronger leg at the same rep count, or the gap between sides never closes.
Going straight to heavy weight. Calf muscle adapts faster than tendon. Spend a few weeks at bodyweight before loading up, especially if you're also increasing your running mileage.
In a 2025 study of 500 healthy adults doing single-leg heel raises to fatigue, the median was 25 reps on the dominant leg and 24 on the other. An earlier study of 566 adults on a 10 degree incline found a median of 24 for men and 21 for women. If you can't reach about 20 clean, full-height reps on each leg, building up to that is a sensible first target, especially if you run.
For bodyweight training, yes. Standing on one foot puts roughly your whole bodyweight through one calf instead of half of it, so the set gets hard in 15 to 25 reps rather than 50. It also shows up any left-to-right difference, which a two-footed raise lets your stronger side hide. Once you're lifting heavy on a machine, double-leg raises are easier to load, and both have a place.
Hold it in the same-side hand as the working leg, so a right-leg raise means the dumbbell sits in your right hand and your left hand holds the wall. The weight hangs straight down over the working foot, which keeps you balanced and leaves your free hand on the support where it belongs.
Progressive calf loading is the backbone of most Achilles tendinopathy rehab, and single-leg raises are usually part of it. In one classic study, 15 recreational athletes with long-standing Achilles tendinosis returned to full running after 12 weeks of heavy eccentric calf training. Tendon pain can have other causes, though, so get it assessed by a physio and follow a plan that sets the load for you.
Do both. A straight knee lets the gastrocnemius (the visible calf muscle) work at a longer length and should be your main version. Bending the knee by about 20 to 30 degrees slackens the gastrocnemius and shifts more of the work to the soleus underneath, which matters for runners because the soleus takes a large share of the load in every stride.
Two or three times a week works well for most people, with at least a day between hard sessions. Calves recover quickly, so light sets most days are fine, but the Achilles tendon adapts more slowly than muscle. If your tendon feels stiff or sore the morning after, ease off rather than piling on more volume.
How to do YTW raises face down on an incline bench, bent over or on the floor. Muscles worked, form cues, how light to go, sets and reps, mistakes and variations.
How to do the hip airplane: step-by-step cues, the assisted version, progressions, common mistakes, and where it fits in your warm-up or accessory work.
How to do a shrimp squat, the single-leg bodyweight squat where you hold your rear foot. Step-by-step cues, regressions, progressions, muscles and sets.
How to do the Kas glute bridge: bench setup, the short top-half range, key cues, sets and load, common mistakes and how it differs from a full hip thrust.
Best Exercise is a participant in the Amazon EU Associates Programme, an affiliate advertising programme designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.co.uk. As an Amazon Associate we earn from qualifying purchases. This comes at no extra cost to you and never influences our independent reviews or rankings.