Skater Squat: How to Do It, Muscles Worked and Progressions
How to do a skater squat, the single-leg bodyweight squat where your rear knee lowers behind you. Cues, muscles worked, regressions, progressions and sets.
By Nadia Popescu, Strength & Conditioning Writer · Updated 21 November 2026
A superset is two exercises done back to back with little or no rest between them, then a normal rest before you repeat the pair. Press, then row, then breathe. That's the whole idea, and the main payoff is time: you get through the same number of sets in roughly half the session, which is why supersets suit anyone training at home before work or squeezing a session into a lunch hour.
There's more to it than speed, though, because the way you pair exercises changes what the superset does. Pair opposing muscles and you lose almost nothing in performance; pair two moves for the same muscle and you'll lift less weight but feel a much bigger burn.
The best summary so far is a 2025 systematic review and meta-analysis in Sports Medicine covering 19 studies and 313 participants. Compared with traditional sets, supersets let people complete a similar number of reps and similar volume load in a shorter session. Long-term gains in maximal strength and muscle size were similar too.
The trade-off is fatigue. Supersets pushed up blood lactate, energy cost and perceived exertion, and the authors suggest you may need slightly longer recovery between sessions. An earlier crossover study from Leeds Beckett University by Weakley and colleagues found the same pattern in 14 trained men: supersets and tri-sets were more time efficient, but jump performance was still down 24 hours later, while it had recovered after traditional sets.
A narrative review on time-efficient training put it bluntly: supersets, drop sets and rest-pause roughly halve training time while keeping volume, though they're probably better for building muscle than for building maximal strength.
You pair muscles that do opposite jobs: chest and upper back, biceps and triceps, quads and hamstrings. While one muscle works, the other gets a rest, so performance on each exercise barely drops. The 2025 meta-analysis found antagonist pairs let people complete more reps than traditional sets, which is a rare free lunch in training.
Examples: dumbbell bench press with a dumbbell row, or bicep curls with overhead tricep extensions.
This is the type to start with.
Two exercises for the same muscle, back to back. Think dumbbell shoulder press straight into lateral raises, or a flat press followed by flyes. It's a brutal way to accumulate fatigue in one muscle, and the pump is enormous. The cost is load: the same review found these "similar biomechanical" pairs led to noticeably less volume load than normal sets. Use them as a finisher, not as the backbone of your programme.
A specific kind of compound set where you do an isolation exercise first, then a compound lift for the same muscle. Leg extensions before leg press is the textbook case. The theory says you tire the target muscle so it has to work harder during the bigger lift. The evidence doesn't back that up. In a 2003 study by Augustsson et al., quad activation during the leg press was actually lower after pre-exhaustion, and people managed fewer reps. If you like pre-exhaust for variety, fine; just don't expect magic from it.
Pair an upper-body move with a lower-body one, such as goblet squats with push-ups. Neither exercise interferes much with the other, so it's very easy to keep good form, and your heart rate stays high throughout. These pairings slot neatly into full-body sessions and into the lower days of an upper/lower split if you want to add some arm or core work.
A tri-set strings three exercises together, and a giant set uses four or more. They push the time saving further and drift towards circuit training. Weakley's study found tri-sets were the most efficient structure of all, though they also produced the highest perceived exertion. Keep them for lighter accessory work or conditioning days.
Two rest periods matter here:
People often cut both rest periods to the bone and wonder why their weights drop by round three. Short rest within the pair is the point; short rest between rounds is optional, and for antagonist work it's the thing that keeps your reps up.
Start with your main lift as a straight set, then superset the rest of the session. A typical 45 minute session might look like one heavy compound lift with full rest, two antagonist supersets, then a single compound set as a finisher for whatever muscle you're prioritising.
A few guidelines that work for most people:
Supersets are especially handy for home lifters with one pair of adjustable dumbbells, because you can set the dials once and run both exercises at the same load if you pick sensible pairs.
Each workout assumes adjustable dumbbells and, ideally, a flat or adjustable bench. Do 3 rounds of each superset unless stated.
| Pair | Exercise 1 | Exercise 2 | Reps |
|---|---|---|---|
| A1/A2 | Dumbbell bench press | One-arm dumbbell row | 8 to 12 each |
| B1/B2 | Seated dumbbell shoulder press | Chest-supported dumbbell row | 10 to 12 each |
| C1/C2 | Bicep curl | Overhead tricep extension | 12 to 15 each |
Rest 90 seconds between rounds of A and B, 60 seconds for C.
| Pair | Exercise 1 | Exercise 2 | Reps |
|---|---|---|---|
| A1/A2 | Goblet squat | Push-ups | 10 to 12 / as many as clean |
| B1/B2 | Dumbbell Romanian deadlift | Dumbbell shoulder press | 10 / 10 |
| C1/C2 | Reverse lunge | Dumbbell row | 10 per leg / 12 |
This one works well for a busy weekday; it rarely takes more than 35 minutes.
Do this after your main session, two rounds only. Dumbbell shoulder press for 10 reps straight into lateral raises for 15, then hammer curls for 12 straight into regular curls for as many reps as you can manage with good form. Rest 90 seconds between rounds and expect the second exercise to feel very heavy.
Leave heavy compound strength work as straight sets. If you're training squats, deadlifts or bench press in the 1 to 5 rep range, you need two to five minutes between sets to lift your best, and adding another exercise eats into that recovery. The 2021 review's point that supersets are probably better for muscle growth than maximal strength backs this up.
Skip them too when technique is still shaky on a new lift, or when you're working towards a specific strength test. Spread across the rest of the session, though, supersets give you the same gains in less time, and for most people training at home that's the deal worth taking.
For more session ideas, browse our workouts hub.
A superset is two exercises performed back to back with little or no rest between them, followed by a normal rest once both are done. A classic example is a set of dumbbell bench press straight into a set of dumbbell rows, then 90 seconds of rest before you repeat the pair.
Yes, as long as total volume stays similar. A 2025 meta-analysis of 19 studies found supersets produced similar long-term gains in strength, strength endurance and muscle size to traditional sets, while cutting session time. They also felt harder and raised blood lactate more, so you may need a little extra recovery between sessions.
Rest as little as possible between the two exercises in the pair, usually 0 to 15 seconds, just long enough to change equipment. Between rounds, rest 60 to 120 seconds for muscle building work, or up to 2 to 3 minutes if one of the lifts in the pair is fairly heavy.
Some coaches use superset only for pairs that hit opposing muscles, such as chest and back, and call two exercises for the same muscle a compound set. In everyday gym talk both are called supersets. The distinction matters because same-muscle pairs reduce how much weight and how many reps you can manage on the second exercise.
Beginners can use antagonist or upper and lower supersets from day one, as they save time without hurting performance much. Same-muscle compound sets and pre-exhaust pairs are better left until you have a few months of training behind you and your technique holds up under fatigue.
You can, but it's a poor idea for most people. Both lifts load the lower back and legs heavily, so the second one suffers and technique tends to break down. Keep heavy squats and deadlifts as straight sets with full rest, and save supersets for accessory work.
How to do a skater squat, the single-leg bodyweight squat where your rear knee lowers behind you. Cues, muscles worked, regressions, progressions and sets.
How to do the reverse Nordic curl safely: step-by-step cues, the muscles it works, why it targets the rectus femoris, regressions, progressions and sets and reps.
How to do an archer push up with clean form. Muscles worked, why it's the best bridge to a one-arm push up, common mistakes, easier and harder variations, and a weekly plan.
How to do a Spanish squat with a heavy band behind your knees. Muscles worked, why physios use it for patellar tendon pain, common mistakes, progressions and a simple sets plan.
Best Exercise is a participant in the Amazon EU Associates Programme, an affiliate advertising programme designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.co.uk. As an Amazon Associate we earn from qualifying purchases. This comes at no extra cost to you and never influences our independent reviews or rankings.